To use this config, the firmware should be compiled for the # AVR atmega1284p.
Klipper category and the excellent macro tutorial Macro Creation Tutorial - #22 by Mard0 Also a lot of inspiration can be obtained.
7k Star 7.
Each micro-controller has a factory assigned unique chip identifier that is used during id assignment.
This happens all the time including after a FIRMWARE_RESTART and a power cycle.
When I try to home the axis by means of clicking the little castle in Mainsail, the axis move ~1cm and just stop.
Contact: Information on bug reporting and general communication with the Klipper developers.
But yeah the homing issue on a large print is a problem.
It is a good idea to run through these steps after following the steps in the installation document.
moonpay vs coinify
baofeng frequency list
management consulting case study pdf
I´m in the middle of setting up Klipper for the first time. I use WinSCP.